Clark's DJ Table · design docs · working draft · updated Oct 9, 2026
Clark's DJ Table
A DJ control surface on an ESP32. Stream from your phone over Bluetooth — or feed it optical or coax — and the table shapes the sound in real time, then sends a line-level pre-out to your amp. Below: how the audio flows, and the front and back panels.
Controls
| Control | Type | Does |
|---|---|---|
| Master volume | 55 mm fader | overall output level |
| EQ — low / mid / high | 3 knobs | boost, cut, or kill each band |
| Filter | 1 knob | low-pass ↔ open ↔ high-pass sweep |
| Echo | 1 push knob | repeats; push the knob to throw an echo on demand |
| Transport | 3 buttons | play/pause, previous, next (over Bluetooth) |
| Source | 1 button | pick input: Bluetooth / optical / coax (shown on OLED) |
| Limiter | automatic | safety net — never clips the amp |
Signal chain
- EQ
- Filter
- Echo
- Volume
- Limiter
Panels — concept
Status & next
- Enclosure laid out for the A1 mini: 172 × 156 mm, 10° slope, print-ready tray + top plate (see the model).
- Still to confirm before printing: the optical, coax and 3.5 mm cutouts.
- v1 is Bluetooth only; optical and coax come later (their cutouts are already in the print).
- Parts picked — see the BOM (ESP32 with u.FL antenna, PCM5102 DAC, WM8804 S/PDIF input, MCP23017 expander for the encoders, HW-233 fader, push encoders).
- Firmware: A2DP + S/PDIF input + AVRCP + the DSP chain + OLED (custom ESP-IDF/Arduino).